Penetrating Sealer Standard

From: $89.00

    • 89 $each

    Quantity Discounts Available:

    • 169 $each
    • 159 $each
    • 149 $each

    • 219 $each

High Performance Impregnator.

 

• Protects against water borne contaminates.
• Eliminates salt ion ingress and efflorescence.
• Will not alter or discolour natural look of substrate.
• Vapour permeable allowing surface to breath.
• Excellent for Interior and Exterior Protection.
• Non-slip.
• Ideal for pool surrounds.
• Will not flake or peel.
• No odour with extremely low VOC.
• Non Hazardous (Worksafe Aust, ADG Code).
• Non-flammable.
• Food Safe

Application
Broom, Brush, Roller or Spray
Coats
Minimum 2 Coats
Coverage
7-13 sqm / L per coat on porous surfaces
N/A on non-porous surfaces
Dry Time
Touch Dry: 30 mins
Re-coat: 5-20 mins
Light Traffic: 3 Hours
Heavy Traffic: 24 Hours
Wash Up
Clean-up immediately on completion with water only. No solvents.
Recommended Uses
External: Driveways, Patios, Footpaths, Retaining Walls etc
Internal: All
Recommended Porous Surfaces
Concrete (incl plain/stencil/stamped/exposed aggregate), Brick/Clay Pavers, Granite, Sandstone, Travertine, Limestone, Bluestone, Terrazzo, Terracotta, Slate, Quartz, Marble & Masonry surfaces.

Water Based - Non-Flammable

Odourless – No Toxic Fumes

Delivered Ready – No Mixing Required

Non-Film Forming - Will Never Peel or Flake

Life – Premium Protection Up To 10 Years

Appearance – Retains Natural Look

⇒First Read General Preparation Guide

Protect any adjacent areas by masking to avoid splashes or over-spray onto surfaces not intended to be treated.
New installations must be fully cured before application.
Existing surface must be totally clean and chemical free.
Surface may be slightly damp.
Do not apply in direct peak sunlight. Temperature must be between 10°C and 28°C.
Apply 1 to 2 coats by generously saturating the surface using a polish applicator, roller or sprayer to an area which can be easily reached. (Approximately 15sqm). Ensure even coverage.
Apply a liberal flood coating giving whole surface a wet look.
The surface must be shiny wet with a liquid film for at least 1 minute. For very porous substrates more sealer may need to be applied.
Allow 5 - 10 minutes for the sealer to absorb into the surface and then move the excess product to a new section.
Wait 5 to 20 minutes and repeat the process. Do NOT allow first coat to fully dry as will repel second coat.
Using absorbent toweling or applicator, wipe off any sealer remaining on surface after 10 minutes of last application. Do NOT allow excess residue to cure on surface as may turn white!
Allow 2 to 6 hours before returning area to traffic. Keep dry for 12 hours.
Achieves a full cure in 24-48 hours.