Non slip texture paint

Forum Home Forums Garage Floor Coatings Non slip texture paint

This topic contains 1 reply, has 0 voices, and was last updated by  Tex Rowe 1 year, 6 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #479 Reply

    Greg

    Hi, just enquiring if your non slip texture concrete paint will go over concrete already coated with berger jet dry aqua tread, i run a motel that has several sections of concrete coated in the berger product that is extremely slippery and hoping your product will rectify this situation.Thanks in advance

    #672 Reply

    Tex Rowe

    Hi Greg apologies for the delay,

    just enquiring if your non slip texture concrete paint will go over concrete already coated with berger jet dry aqua tread

    Unfortunately we have not tested our product over your existing brands coating though in general terms most coatings are re-coatable subject to correct preparation determined by applicator.
    In addition, if a single pack solvent were previously used then best to stick with a solvent once more.
    If a single pack water based were previously used then best to stick with a water based product once more.
    All 2 packs require some form of abrasion before re-application.
    Please also note our non-slip paint is highly textured so not normally used for garage floors. Most applicators opt for our Concrete Paint Sealer with the addition of our Extra Grip Additive. This way an applicator can determine how much or how little grip is required on site. Once again though we have not tested our product over your existing brands coating.
    Sorry we cannot be more helpful.

Viewing 2 posts - 1 through 2 (of 2 total)
Reply To: Non slip texture paint

This board is for pre-sales questions. Do not post support requests for purchased products as per Board Rules and Agreement .

Your information: